DDR3L Kingston HyperX Fury 1600MHz 8GB Kit - HX316LC10FBK2/8 (KIT 2DB)

HyperX HX316LC10FBK2/8 is kit of two 512M x 64-bit (4GB)

DDR3L-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8, low

voltage, memory modules, based on eight 512M x 8-bit DDR3

FBGA components. Total kit capacity is 8GB. Each module kit

supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.

This module has been tested to run at DDR3L-1600 at a low

latency timing of 10-10-10 at 1.35V. Additional timing parameters

are shown in the PnP Timing Parameters section below.

The JEDEC standard electrical and mechanical specifications

areas follows:

JEDEC standard 1.35V and 1.5V Power Supply

• VDDQ = 1.35V and 1.5V

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE ≤ 95°C

• Asynchronous Reset

• Height 1.291” (32.80mm) w/heatsink, single sided

component