Notebook DDR3 Kingston 1600MHz 2GB - KVR16S11S6/2

DESCRIPTION

This document describes ValueRAM's 256M x 64-bit (2GB)

DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx16,

memory module, based on four 256M x 16-bit FBGA components.

The SPD is programmed to JEDEC standard latency

DDR3-1600 timing of 11-11-11 at 1.5V. This 204-pin SODIMM

uses gold contact fingers. The electrical and mechanical

specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6, 5

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), single sided component